How To Clean Battery Acid From Concrete

Stained concrete floor. — Acid-stained physical can be hard to wait at — and even harder to clean.

Removing any type of stain is challenging because nearly physical surfaces are not sealed with a masonry sealer, which nosotros highly recommend.

To remove an acid stain from concrete, the first thing to exercise is to clean the surface with another acid — muriatic acid, specifically. It will need to be diluted before using; a 3:i dilution with 3 water should do the flim-flam!

Note: this acrid is chemically potent and dangerous, so be extremely cautious when using this.

In one case you utilize the diluted muriatic acid, it should start to bubble in reaction to the acid stain on the concrete surface.

Generally, this should lift the acid stain out, but you may have to echo this process a couple of times, and then have a water hose handy to flush it out.

Another way of removing an acid stain from physical is to utilize oxalic acid. This acid, like muriatic acid, volition as well demand to be diluted earlier use. Brush it onto the stain and and then permit it sit for about 15-20 minutes — be sure to go along the stain moisture; don't let it dry up!

After keeping the stain wet for the designated time, scrub the acid stain with a nylon bristle brush and rinse the area well. Never utilize a wire brush on concrete, information technology can change the texture of the physical.

Listen to the Today's Homeowner Podcast to larn more about these topics:

Screening in a section of your patio with a complicated roof line
What to do when your dwelling house has a musty odor from constant moisture
What to do when you have damaged particle board countertops
Landscape fabric recommendations
Tips for fixing incorrectly installed insulation

Best New Product

Simple Solutions

Stone and Roll — Side by side time you need to move a heavy rock or stone slab, try this trick: Accept a length of four-inch-diameter Schedule xl PVC pipe and cut it into 3-foot-long sections. Pry up the stone and sideslip two pipe sections underneath; one near the middle, the other near the front terminate.

Fix the third pipe about 12 inches or so in front of the rock.

Now, push button the rock forwards until it rolls onto the tertiary pipe, and the get-go piping comes gratis. Then, motion the first pipe to the front and repeat the process until you achieve your destination.

Popcorn Painting — When painting the walls of a room that has a popcorn ceiling, it's almost impossible non to become paint on the protruding popcorn texture.

Here's how to neatly and easily paint along the top of the wall:

Run the tip of a slotted screwdriver effectually the perimeter of the ceiling, scraping off a little bit of the texture. The screwdriver creates a tiny groove in the ceiling, which the tips of the paint bristles fit into.

At present, you can cut in around the ceiling without getting paint on the ceiling. And you'll never notice the narrow groove.

Question of the Week

Q: Do I demand to remove the sometime epoxy covering before applying a new coat on my garage floor?

A: If at that place'due south no problem with information technology — like peeling or other damage — some light sanding and a well-cleaned surface are all you demand to do for prep.

However, if your epoxy-covered floor is peeling or has noticeable wear, practice not apply new epoxy — this volition cause the epoxy to neglect. In this instance, yous would need to grind the surface back downwards to the physical.

Moreover, if the epoxy is in proficient status, you tin apply a new epoxy blanket over the old one.

Note: If the old epoxy has a clear coat cease on superlative of it, this will demand to be removed before applying new epoxy. Check with the manufacturer for the best mode to remove the clear glaze.